This device features greater RFID collecting function and battery life
High performance RFID module + 5dBi Circularly Polarized (CP) antenna
Up to 20m reading distance, more than 700 tags/s reading rate
It saves 40% of your time when you make mass inventories
There’s a 15° included angle between the screen and the RFID antenna, the camera, and the scanning head
When you use RFID to read, to photograph,and to scan;
It’s a fatigue-free design for users to see the screen without lowering their heads
It adopts fin-shaped metal heat sink+build-in fans
Dual heat sinks make the heat dissipation more efficient
It guarantees the stable operation of the module by
lowering the average working temperature by 10℃.
It adjust the RFID working time dynamically based on the quantity of the tags;
It improve the module’s efficiency, thus extending the lifespan of the module;
It reduce heat and optimize the power consumption of the whole device
4500mAh build-in battery in housing + 6500mAh detachable battery in handle
The battery of house can guarantee the stable operation when you replace the battery of the handle.
It’s time-saving that there’s no need to reset and re-login.
The battery is in the bottom part of the handle, so the gravity locates right at the center
When you hold it,your finger can pull the trigger easily.
The peak rate can reach up to 20Gbps,while the lowest delay is just a few milliseconds.
Dual-Sim dual-standby, you can choose your network carrier freely with a better performance.
6.21-inch water drop screen,1520*720 ultra-high definition, the display is more clear than ever.
Octa-core 2.0GHz CPU + Android 11.0, the operating speed is faster than ever
It supports MU-MiMo multi-channel Wi-Fi transmission, better performance and higher rate.
|Processor||Octa-core 2.0GHz high-performance processor|
|Memory (ROM+RAM)||64GB + 4GB (standard), 128GB+6GB(optional)|
|SIM||Two out of three SIM card slots, support dual SIM and dual standby
*Two out of three SIM card slots: two cards can be held at the same time, Nano SIM card + Nano SIM card /Nano SIM card +TF card
|Expansion Slot||Micro SD card (up to 256 GB)|
|Display Screen||6.21-inch, resolution: 1520*720 pixels|
|Touch Screen||Industrial capacitive screen, support wet-hand operation/glove mode/multi-touch/gesture operation|
|Camera||16 megapixels top camera, support auto-focus/PDAF, 5 megapixels front camera;|
|Keypad||6 keypads in total: scan key *2, power key *1, volume key*2, pistol trigger *1|
|Battery||3.85V lithium battery, with 4500mAh, undetachable
3.7V lithium battery, with 6700mAh, detachable
|Charging Method||Type-C and Pin-port charging, support 18W fast charging|
|Reminder||Vibration reminder/LED reminder/high power speaker/Audio reminder|
|Vibrating Motor||Built-in vibrating motor|
|Sensor||G-sensor/Proximity sensor/Light sensor/Geomagnetic sensor/ Gyroscope|
|Intercom Function (Optional)||Support one-button PTT calls|
|Cooling fan (Optional)||Built-in cooling fan|
|Weight||680g (including the battery)|
|WWAN (Network Frequency)||China & Eurasian version:
4G: FDD-LTE：B1/B3/B7/B8/B20， TDD-LTE：B34/B38/B40
|WWAN (Data Service)||GSM/GPRS/EDGE/CDMA/UMTS/HSPA/HSPA+/EVDO/WCDMA/TD-SCDMA/TDD-LTE/FDD-LTE|
|WLAN Function||Wi-Fi 802.11a/b/g/n/ac/d/e/h/i/j/k/r/v/w (2.4G + 5G dual-band Wi-Fi), support fast roaming|
|Working Temperature||-20℃ - 60℃
*Do not charge under low temperature conditions for the safety Concerns
|Storage Temperature||-40℃ - 70℃（Without battery）|
|Humidity||0 - 95% (no moisture condensation)|
|Drop Specification||Multiple drops to concrete floor from the height of 1.5m|
|Roller Drop Specification||1000 times of roller drops from a height of 0.5 meter|
|ESD Protection||±15KV (air discharge), ±8KV (contact discharge)|
|Barcode Type||It can scan one-dimensional / two-dimensional barcodes|
|Scanning Angle||Pitch: ±60°； Skew：±45°； Tilt：360°|
|Motion Error Tolerance||8m/s|
|Working Frequency||13.56 MHz|
|Reading Distance||Within 60 mm|
|Communication Protocol||ISO18000-6C/EPC Class1 Gen2|
|Antenna||Circular polarization antenna|
|Reading Distance||Up to 20m|
|Reading Rate||Up to 700tags/s|
|USB Interface||Type-C (with headset function) *1|
|PSAM (Optional)||Support PSAM*1|
|Development API||iScan API (Scanning Development Kits), Device API (Device Management/Configuration Development Kits), Android Standard Interface|
|Development Tool||Eclipse/Android Studio|
|Standard Accessories||USB cable*1, power adapter*1|
|Optional Accessories||Single charging cradle, 4-slot charging cradle, 2-slot battery charging cradle, protective film|
|******||As the product line is updating from time to time, the information in this document is subject to change without notice.