5G portable RFID mobile terminal
This device features user-friendly RFID collecting function and greater portability
High performance RFID module + 2dBi Circularly Polarized (CP) antenna
It supports fast reading of mass tags, small module but powerful functionality
The gripping is as thin as 13.7mm only, super convenient and portable
The power of antenna can be adjusted in a wide range.
The reading distance can be either far or close,the furthest distance can reach up to 6m;
It can be free from the disturbance of other tags nearby.
It adjust the RFID working time dynamically based on the quantity of the tags;
It improve the module’s efficiency, thus extending the lifespan of the module;
It reduce heat and optimize the power consumption of the whole device
With a 4500mAh big battery, it supports up to 1.5 shift working time.
The battery is detachable, which can be replaced easily and continue to work;
It supports 18W fast charging, it can be fully charged during the shift change
The peak rate can reach up to 20Gbps,while the lowest delay is just a few milliseconds.
Dual-Sim dual-standby, you can choose your network carrier freely with a better performance.
6
.21-inch water drop screen,1520*720 ultra-high definition, the display is more clear than ever.
IP67 protection level+ Up to 1.5m concrete ground impact resistance
It fits different complex scenarios, sturdy and safe.。
| System Configuration | |
| Processor | Octa-core 2.0GHz high-performance processor |
| Operating System | Android12.0（GMS） |
| Memory (ROM+RAM) | 64GB + 4GB (standard), 128GB+6GB(optional) |
| SIM | Two out of three SIM card slots, support dual SIM and dual standby * Two out of three SIM card slots: two cards can be held at the same time, Nano SIM card + Nano SIM card /Nano SIM card +TF card |
| Expansion Slot | Micro SD card (up to 256 GB) |
| Display Screen | 6.21-inch, resolution: 1520*720 pixels |
| Touch Screen | Industrial capacitive screen, support wet-hand operation/glove mode/multi-touch/gesture operation |
| Camera | 16 megapixels top camera, support auto-focus/PDAF; 5 megapixels front camera |
| Flashlight | 800mA flashlight |
| Keypad | 5 keypads in total: scan key *2, power key *1, volume key*2 |
| Battery | 3.85V lithium battery, with 4500mAh, undetachable 3.85V lithium battery, with 4200mAh, detachable |
| Audio | Built-in microphone |
| Charging Method | Type-C and Pin-port charging, support 18W fast charging |
| Reminder | Vibration reminder/LED reminder/high power speaker/Audio reminder |
| Vibrating Motor | Built-in vibrating motor |
| Sensor | G-sensor/Proximity sensor/Light sensor/Geomagnetic sensor/ Gyroscope |
| Intercom Function (Optional) | Support one-button PTT calls |
| Structural Parameter | |
| Dimension (L*W*D) | 168mm*79mm*13.7mm (Thickest 25mm) |
| Weight | 315g (including the battery) |
| Communication Transmission | |
| WWAN (Network Frequency) | China & Eurasian version: 2G: 900/1800 3G: WCDMA：B1/B8 4G: FDD-LTE：B1/B3/B7/B8/B20， TDD-LTE：B34/B38/B40 American version: 2G: B2/B3/B5 3G: B1/B2/B4/B5，CDMA&EVDO：BC0/BC1 (U.S.) 4G: B1/B2/B3/B4/B5/B7/B12/B17/B28A/B28B |
| WWAN (Data Service) | GSM/GPRS/EDGE/CDMA/UMTS/HSPA/HSPA+/EVDO /WCDMA/TD-SCDMA/TDD-LTE/FDD-LTE |
| WLAN Function | Wi-Fi 802.11/a/b/g/n/ac/d/e/h/i/j/k/r/v/w (2.4G + 5G dual-band Wi-Fi), support fast roaming |
| Bluetooth | Bluetooth 5.0 |
| GPS | GPS |
| Environmental Parameter | |
| Working Temperature | -20℃ - 60℃ *Do not charge under low temperature conditions for the safety Concerns |
| Storage Temperature | -40℃ - 70℃ (without battery) |
| Humidity | 0 - 95% (no moisture condensation) |
| Drop Specification | Multiple drops to concrete floor from the height of 1.5m |
| Roller Drop Specification | 1000 times of roller drops from a height of 0.5 meter |
| Ingress Protection | IP67 |
| ESD Protection | ±15KV (air discharge), ±8KV (contact discharge) |
| Scanning Engine | |
| Barcode Type | It can scan one-dimensional / two-dimensional barcodes |
| Scanning Accuracy | ≧3.33mil |
| Scanning Angle | Pitch: ±60°； Skew：±45°； Tilt：360° |
| View Angle | Horizontal：44.3°，Vertical：28.4°，Diagonal：51° |
| Motion Error Tolerance | 8m/s |
| UHF RFID & LF RFID | |
| Communication Protocol | UHF RFID：ISO18000-6C/EPC Class1 Gen2 LF RFID：EMID/FDX-B |
| Frequency | UHF RFID：920MHz~925MHz/902MHz~928MHz/865MHz~868MHz |
| Output Power | 0~25dbm(standard); 5~30dm(optional) |
| Antenna | Circularly polarized antenna |
| Reading Distance | UHF RFID：0~25dbm, up to 3m (standard); 5~30dm, up to 5m (optional) LF RFID：3~5cm |
| NFC (Optional) | |
| Working Frequency | 13.56 MHz |
| Reading Distance | Within 60 mm |
| Communication Protocol | ISO14443A/14443B/15693 |
| Communication Interface | |
| USB Interface | Type-C (with headset function) *1 |
| OTG Interface | Support |
| Development Support | |
| Programming Language | Java |
| Development API | iScan API (Scanning Development Kits), Device API (Device Management/Configuration Development Kits), Android Standard Interface |
| Development Tool | Eclipse/Android Studio |
| Accessories | |
| Standard Accessories | USB cable*1, power adapter*1, hand strap*1, device-back strap*1, battery*1 |
| Optional Accessories | Single charging cradle, bottom charger, 4-slot charging cradle, 4-slot battery charging cradle, fanny pack, protective film, protective case |
| Note | |
| ****** | As the product line is updating from time to time, the information in this document is subject to change without notice. |
Contact
